Message |
---|
| Member | ikornev Moscow 30-05-2010 18:18 Posts 14 |
|
| Message Edit 18:32 - 30-05-2010 user ikornev
Hello! Advice is needed. Bought Thorens single claw in excellent condition. Inserted flint zippo, bosses (petrol, too, zippo). I lit the first time, I checked several times - works fine. He took a cigarette lighter in an hour - dead. I tried to change the flint, refueling nothing helps. Kakko can be cunning ???? |
|
| Member | sspas 30-05-2010 18:21 Posts 534 |
|
| And what is dying, there is no spark or something else? |
|
| Member | ikornev Moscow 30-05-2010 18:22 Posts 14 |
|
| The spark is there, but does not ignite. |
|
| Member | sspas 30-05-2010 18:33 Posts 534 |
|
| Spark is a good, ie, It is the same as it was when ignited? Wick normally sticks? |
|
| Member | ikornev Moscow 30-05-2010 18:37 Posts 14 |
|
| Yes, everything seems fine. And how much should hang around the wick? |
|
| Member | sspas 30-05-2010 18:49 Posts 534 |
|
| Petrol Lighter starts if the wick soaked with gasoline gets a spark. If no spark, the causes can be either lighter mehannike (not spinning wheel or scored), or flint or is bad or not, or a soak (water, gasoline, etc. saliva. Liquid). If the spark is there a problem in the fuel system. Mild sticks (or not in) a wick, or it ran out of gas is not supplied to the wick. Or it's not gasoline. :) More then there can be nothing. If there is a spark and the wick is normal sticks, try to ignite, even from the match. How will ignite, it could even dry. |
|
| Administrator | kypexin Moscow 30-05-2010 18:57 Posts 504 |
|
| And Thorens fingered before that the insides? This can be done if the cotton 70 years have not changed, and it rotted; It may be due to the fact that the wick is lagging behind the stub of 1 cm, which is sticking out, and inside is not wetted with gasoline, and so on. That is, at 100%, you can be confident in the performance, if he go through the gut, competently put the normal length of the wick (at least sanimetrov 10) and replace cotton. And while yes, it could be one - the wick is not wetted with gasoline, for whatever reason. | |
|
| Member | ikornev Moscow 30-05-2010 18:59 Posts 14 |
|
| Thank you for "LIKBEZ", even though I did not really very experienced collector, but how works Lighter guess. From stichki it lights and, of course, I was on the wheel, I did not spit and water are not watered. However, the Kindle, as it should, it does not want. |
|
| Member | ikornev Moscow 30-05-2010 19:04 Posts 14 |
|
| Thanks for the advice. Lighter on my untrained eye not folding. Is it possible to replace the wick and cotton? |
|
| Administrator | kypexin Moscow 30-05-2010 19:17 Posts 504 |
|
| ikornev writes: Thanks for the advice. Lighter on my untrained eye not folding. Is it possible to replace the wick and cotton?
Of course :) She is the pope has a screw through which you refuel it? There's wool. So, through this hole is removed and wool, and the fuse changed. However, if no experience, I do not advise to do it - on their first time, this task is not as trivial :) In general, yes, the description is non-wetting of the wick or gasoline, or a weak spark. As soon as a match lit the fuse ... Try to put another flint for example? | |
|
| Member | sspas 30-05-2010 19:17 Posts 534 |
|
| I did not want to offend anyone, I apologize ate it seemed rude. Just describe a common cause, for example if you have zippopodobnyh strike sharply wet or sweaty fingers, and if the first attempt does not zazhgetsya, then the second is not exactly light up. For the present case this does not apply, other structure. In your case, if there is a spark and the wick wetted with gasoline, then I would check the quality of gasoline, even be on the other lighter. Most likely it is not zippovsky gasoline. Or maybe even inside lighters present or formed over time kakayal muck Totoro somehow changes the properties of gasoline. remove and change the packing is possible through the filler hole. |
|
| Member | ikornev Moscow 30-05-2010 19:26 Posts 14 |
|
| Message Edit 19:49 - 30-05-2010 user ikornev
Thank you very much for the advice. I was not offended, just had to be like that react. I tried to change the flint and gasoline - is good, it is not It helps. It seems to me, lighters have this quite a distance from the wheel with silicon to wick and may need a stronger spark. Maybe I should try to clean the wheel? If you do not help, you can contact help to replace the wick and cotton? |
|
| Member | Hartman 30-05-2010 19:33 Posts 481 |
|
| As a staff Captain Obvious, I note - the fuel - liquid is not flammable, burning gasoline vapors mixed with air. ;) In fliptopov is such a moment - with full fuel and drenched the wick are in the room are off, the lid accumulate those same couples, and there is no air and that lighter worked - it is necessary to blow on the windscreen or a little shake his lighter and then strike sharply, otherwise it will be micro-explosion of vapors and the flame will be. |
|
| Administrator | kypexin Moscow 30-05-2010 19:40 Posts 504 |
|
| ikornev writes: Thank you very much for the advice. I was not offended, just had to be like that react. I tried to change the flint and gasoline - Horsham, this is not It helps. It seems to me, lighters have this quite a distance from the wheel with silicon to wick and may need a stronger spark. Maybe I should try to clean the wheel? If you do not help, you can contact help to replace the wick and cotton?
Igor gladly help you, if the problem is not solved itself :) Write, Contract, pass me a cigarette lighter for a couple of days. | |
|
| Member | ikornev Moscow 30-05-2010 19:47 Posts 14 |
|
| Thank you very much for participating, try cleaning the wheel. If you do not help to ask for help. |
|
| Member | Yurii 31-05-2010 18:58 Posts 327 |
|
| I had a similar problem. The point here is not likely in gasoline and in cotton. Rather beam sparks produced by the rotation, uh .. tight enough. The distance between the wheel-wick is actually more than the others. Lighters. Therefore, the beam must be greater than sparks. In my case I solved this problem by careful selection of the flint wheel and cleaning may matter flint pressing spring. Like this. )) |
|
| Member | ikornev Moscow 01-06-2010 12:14 Posts 14 |
|
| Thanks for the advice, Yuri. Sorry for the question, "teapot", and how to choose a flint and what better to put in such a situation? The same would be very grateful if somebody could describe subtleties to replace the wick and filling in some of these lighters put the wick. |
|
| Administrator | kypexin Moscow 01-06-2010 12:21 Posts 504 |
|
| ikornev writes: Thanks for the advice, Yuri. Sorry for the question, "teapot", and how to choose a flint and what better to put in such a situation? The same would be very grateful if somebody could describe subtleties to replace the wick and filling in some of these lighters put the wick.
The wick should be to cotton and thick, such as "string", as the old Ronson, zippovsky reinforced should not put - looks ugly. Subtleties immediately obvious: we need a fine forceps :))) Well, sure hand, of course, pervosti pull all cotton through a narrow opening is not easy. Vata can take an ordinary cotton in the pharmacy, cotton balls. The wick is inserted from the top, moisten the tip and roll, and then push, as if slightly screwing on short length; then pick up a pair of tweezers and pull from within. The length of it should be at least 10. cm Sometimes the truth is necessary to fasten the wire at the end of the wick and pulling for her, if so he crawls or not it is difficult to pick up from the inside. In general, anything super complicated in this, but the first ever protrahatsya can sometimes be pretty :) | |
|
| Member | ikornev Moscow 01-06-2010 13:16 Posts 14 |
|
| Thank you, I have another old Thorens, It will try to work out (when all the It is for the first time). If you fail will return for help, as agreed. Good luck! |
|
| Member | Yurii 01-06-2010 14:16 Posts 327 |
|
| Generally they mnogo..zippovskie, an old alfa, you can try black jobon noname kakoy- or anything. I earned the old black, here it is necessary to experiment in short, can and will approach from the one-time ... |
|